parker valve manufacturer, parker valves distributor, parker valve factory--China Deland Valves Manufactring

Set up in 1995, China Deland Valves Manufactring Co.,Ltd. is one of the leading parker valve manufacturer, supplier and distributor in Yongjia County of Zhejiang Province. We manufacture all parker valves strictly conforming to the API, JIS, ANSI, BS, GB, NF and DIN standards. Our parker valves are available to users on request and are used for municipal works, petroleum, chemical industry, power station, metallurgy, national defense, and scientific research fields. We can supply custom, used, discount, cheap parker valve and accessory to USA, UK, Canda, Amercia, Europe, Germany, France, Japan, India, Iran, Russia, Poland and more than 30 countries in the world.

Parker Solenoid Valve P/N 16F24C2164A3F4C80, 24vdc, 1 NPT, NC, 5-125 psi, Buna N Seals, Brass Body. The Series 22/23/24 2-way solenoid valve is Parker's best selling series of Solenoid Valve. The valves are pilot operated and are general purpose solenoid valves for air, water and light oils. The 16F24C2164A3F4C80 is the same form, fit and function as the ASCO 8210G4 24vdc valve and is normally stocked.
Max Working Pressure: 150PSI
Max Burst Pressure: 300PSI
Port Size: 1/2"
Orifice Size: 5/8"
CV Factor: 4.0
Voltage: 12 Volts
Amperage: .5 Amps
4-Valves Required For Front And Back Setup
8-Valves Required For Front, Back, Side, Side Setup

Parker 2-Way Solenoid Valves: Skinner's Gold Ring Two-Way solenoid valve portfolio offers an extensive selection of products for a broad range of general purpose applications for fluids and gases. Sizes range from 1/8" to 3" NPT, brass or stainless steel bodies, with Cv's as high as 125.
Parker Solenoid Valve P/N 02F20C1108AAF4C05, 120 vac, 1/8 NPT, NC, 0-155 psi air, 0-180 psi water, 0-140 psi oil, Buna N Seals, Brass Body. The 8262 series is a direct acting 2-way solenoid valve valve with no minimum pressure requirements. Parker Valve Part number 02F20C1108AAF4C05.
The valve, shown in Figure 1, has a clearly labeled pressure (P) and return side (R).
For convenience, the P and R should be etched on the appropriate sides of the valve before testing begins so that the actual orientation of the valve is known throughout the duration of the experiment.